Add, Edit, and Delete Linear Pavement Marking

As linear pavement markings are physically added or changed, it is advisable to use the Laptop Data Collector (LDC) for Linear Pavement Marking data collection; however, for agencies that use a distance measuring instrument (DMI) or other type of data collection aside from the LDC, entries can be made in Roadsoft. Linear marks can be added, edited, and deleted within the Linear Mark Module.

Add a Linear Pavement Marking

With the Linear Pavement Marking layer visible and active:

Select the desired segment.

Select View Module from the map menu.

In the Linear Marks tab, select the desired mark icon. Use the scroll bar to see the full list of marks.

The Use Last Marks button will add the same marks (in the same order initially selected) that were used in the last entry saved.

Enter the linear mark data (Material, Offset Side, Offset, Width, Memo) in the section below if defaults were not set. See Set Linear Pavement Marking Defaults, for instructions on setting defaults.

Select the Save button.

Edit a Linear Pavement Marking

With the Linear Pavement Marking layer visible and active:

Select the desired linear mark.

Select View Module from the map menu.

Select the mark to edit from the available Current Marks.

Edit the linear mark data (Material, Offset Side, Offset, Width, Memo) in the section below.

Select the Save button.

Delete a Linear Pavement Marking

With the Linear Pavement Marking layer visible and active:

Select the desired linear mark.

Select View Module from the map menu.

Select the mark to delete from the available Current Marks.

Select the trash icon.

Select the Yes button.